Readers ask: How To Replce The Carburetor On A Poulan Mofel P3314 Chain Saw?

How do you change the carburetor on a Poulan P3314 chainsaw?

This article provides step-by-step instructions for replacing the carburetor on a Poulan chainsaw.

  1. Let’s get started.
  2. Remove the top cover.
  3. Remove the air filter housing.
  4. Remove the carburetor.
  5. Remove the starter assembly.
  6. Disconnect the fuel lines.
  7. Remove the purge bulb.
  8. Remove the choke lever.

How do you change the carburetor on a Poulan Pro chainsaw?

How to Replace the Carburetor on a Poulan Pro Chainsaw

  1. Let’s get started.
  2. REMOVING THE CARBURETOR 1. Drain the fuel.
  3. Remove the air filter.
  4. Remove the starter assembly.
  5. Remove the top cover.
  6. Remove the air filter base.
  7. Remove the choke lever.
  8. Disconnect the throttle linkage.

Can’t get my Poulan chainsaw started?

If your Poulan chain saw won’t start, the first thing to check is the fuel. Then turn the saw on, hold it firmly and pull the start rope in short, brisk pulls until it starts. If it doesn’t start within 15 pulls, the spark plug is likely wet-fouled. Remove it and check for moisture on the electrode.

How do you troubleshoot a Poulan chainsaw?

Poulan Pro Chainsaw Troubleshooting

  1. Make sure you are starting the engine properly.
  2. Fill the tank with the correct fuel mixture.
  3. Clean the saw blade.
  4. Check the fuel line for kinks or leaks.
  5. Replace the fuel filter.
  6. Clean the air filter.
  7. Remove and replace the spark plug.
You might be interested:  Quick Answer: How To Remove Carburetor Briggs And Stratton?

How do I get my chainsaw to idle?

First set the idle speed by setting it as high as possible without engaging the clutch (close to 2700 RPM if you have a tachometer). Then set the low-speed screw by turning it gently in until the engine begins to starve for fuel, then turn it out gently until the engine loads up.

Does carburetor cleaner work?

Most carburetor cleaners do the work for you, no scrubbing required. Readily available and affordable. Most auto parts stores will carry a few brands of carburetor cleaner. Typically less than $20, carburetor cleaners are a cheap, efficient way to improve the overall performance of your vehicle.

How do you replace a carburetor?

Compare the old carburetor to the new carburetor to verify that you have the correct part. Remove the gasket between the carburetor and intake manifold and replace it with a new gasket. Carefully set the new carburetor onto the new manifold gasket. Install the mounting nuts and tighten them securely.

How does a diaphragm work on a carburetor?

A flexible diaphragm forms one side of the fuel chamber and is arranged so that as fuel is drawn out into the engine, the diaphragm is forced inward by ambient air pressure. As fuel is replenished the diaphragm moves out due to fuel pressure and a small spring, closing the needle valve.

Can you use seafoam in a chainsaw?

Making sure the fuel is fresh will go a long way toward making a saw run well consistently. At Sea Foam, we recommend overcoming saw starting issues by adding 2–4 ounces of Sea Foam Motor Treatment to a low tank of fuel, running it for about five minutes, then letting it sit a night or two to soak or clean.

Leave a Reply

Your email address will not be published. Required fields are marked *