Readers ask: How To Adjust Carburetor Poulan String Trimmer Pp325?

Why does my trimmer dies when I give it gas?

Why does my weed eater die when giving it gas? The most common causes of a weed eater dying when throttled are fuel issues, insufficient air intake, or problems with the exhaust. You should follow the path that the fuel travels to identify the issue.

How do you adjust a high and low carburetor?

Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.

Is it illegal to own a carburetor adjustment tool?

it is illegal by EPA regulations to sell carburetor adjusting tools and illegal to buy them unless you are a servicing dealer.

Why does my string trimmer keeps stalling?

A clogged fuel filter is most commonly caused by leaving fuel in the string trimmer for a long period of time. This sticky fuel can clog up the fuel filter and cause the engine to stall. If old fuel was left in the string trimmer, drain the old fuel from the fuel tank and replace the fuel filter.

You might be interested:  Question: How To Clean Carburetor On A 2007 660 Grizzly?

Why does my trimmer only run on full choke?

When your trimmer starts and runs on choke, it could be because the check valve in the gas cap is clogged. Start the trimmer and gently unscrew the gas cap halfway off. Turn the choke off and assess. If the engine is still running, that means the gas cap may be the culprit.

Why does my Echo edger won’t stay running?

A clogged carburetor is often caused by leaving fuel in the edger for a long period of time. Over time, some of the ingredients in the fuel will evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall or run roughly.

Why does my Poulan chainsaw dies when I give it gas?

The fuel filter might be clogged. A clogged fuel filter is often caused by leaving old fuel in the chainsaw. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and cause the engine to stall.

How do you adjust the carburetor on a Poulan wild thing?

Never adjust the carburetor on a cold engine. While idling, turn the “L” screw clockwise all the way in until the engine makes a higher-pitched whine. Back the screw out one-quarter turn and note its position. Then turn it back counterclockwise until the engine starts running rough or dies.

Leave a Reply

Your email address will not be published. Required fields are marked *