How do you adjust the carburetor on a Weedeater blower?
Adjust the Carburetor on a Weedeater Featherlite
- Adust both screws clockwise until just tight using the correct tool.
- Rotate the HI screw one and a half full turns counter-clockwise.
- Rotate the LO screw one full turn counter-clockwise.
- Open the choke by pulling the choke level all the way out or turning it to full.
How do you adjust the idle on a leaf blower?
Start the blower engine, and allow the leaf blower to run at high idle for one minute. Turn the throttle lever down to the slow position, and allow the leaf blower to idle. If the blower shuts off, turn the idle screw 1/8 turn clockwise with a flathead screwdriver. Start the engine, and allow the engine to idle.
Is it illegal to own a carburetor adjustment tool?
it is illegal by EPA regulations to sell carburetor adjusting tools and illegal to buy them unless you are a servicing dealer.
How do you adjust a high and low carburetor?
Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.
Why does my leaf blower dies when I give it gas?
If the air filter in your leaf blower is partially plugged, it can cause your engine to run, but die at full throttle. The air filter is designed to prevent debris from entering the engine, and over time this debris can accumulate and lead to a clog. A clogged air filter may cause your blower to idle roughly as well.
How do you adjust a gas blower?
- Flush the fuel tank of old gasoline.
- Clean the outside of the carburetor and the space around it.
- Clean the fan blades on the flywheel.
- Check the fuel filter and the fuel line.
- Check all the cables and the connections.
- Change the spark plug if needed.