Readers ask: How To Adjust A Craftsman Weed Eater Carburetor?

Why does my Craftsman weed eater dies when I give it gas?

Sometimes a weed eater will start, and even idle just fine, but when you give it gas, it dies. This is often a sign that the engine is struggling to get sufficient amounts of either fuel or air.

How do you adjust a craftsman carburetor?

How to Adjust a Carburetor in a Craftsman

  1. Locate the carburetor on your Craftsman equipment.
  2. Turn the main mixture and idle mixture screws on the carburetor counterclockwise about one full turn with a flat-head screwdriver.
  3. Start the engine with the transmission in neutral and let it run for several minutes.

How do you adjust a high and low carburetor?

Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.

Is it illegal to own a carburetor adjustment tool?

it is illegal by EPA regulations to sell carburetor adjusting tools and illegal to buy them unless you are a servicing dealer.

What causes a weed eater not to stay running?

The Final Word Remember: If your weed trimmer starts but won’t keep running that’s usually a sign of either a poor fuel/air mix or an easy-to-replace filter having gotten clogged, all of which are easy fixes to perform at home.

You might be interested:  Readers ask: How To Adjust A Carburetor On A Homelite 26b Blower?

What causes a weed eater to backfire?

If the engine runs better when you turn the choke on then you might have a restriction in the fuel lines or carburetor itself or possibly an intake air leak. The backpressure can cause backfiring and rough running and in some cases will prevent the engine from starting at all.

Leave a Reply

Your email address will not be published. Required fields are marked *