- 1 Where are the numbers on a Walbro carb?
- 2 How do I tell what model my carburetor is?
- 3 What is a carburetor number?
- 4 Are Walbro carbs good?
- 5 Where are Walbro carbs made?
- 6 What size carburetor do I need for a 350?
- 7 How do I identify Barry Grant carburetor?
- 8 What is a 4150 style carburetor?
- 9 How do I know if I have a 2 barrel carburetor?
- 10 How much is a carburetor rebuild kit?
Where are the numbers on a Walbro carb?
The Walbro part numbers and letters can be found next to the adjustment needles on some of our larger models like the HDA and HDB series carburetors, and near the fuel inlet fitting on our WT and WA series.
How do I tell what model my carburetor is?
The list number is stamped on your carburetor, either on the corner of the airhorn or choke tower or, if it doesn’t have an airhorn, on the mainbody. Remove the carburetor from your vehicle before looking for the list number to easily find the information you need.
What is a carburetor number?
It’s like a “VIN” for your carburetor and should be hand-stamped on the front of the choke tower to the right of the vent tube on most typical Holley carbs. The list number typically is four to six digits long and may or may not have a suffix number behind it. The date code will be right below it.
Are Walbro carbs good?
Only good thing is the carbs are dirt cheap to replace when they foul up. And they will foul up no matter how picky you are with fuel quality. Zama is owned by Stihl or part owned by Stihl and has their main factory in Japan. They are excellent carbs,no better or o worse than the equivalent Walbro.
Where are Walbro carbs made?
Walbro is a global organization, headquartered in Tucson, Arizona, with over 2300 employees worldwide. The company has ISO certified manufacturing and engineering facilities in the United States, Japan, Mexico, Thailand and China.
What size carburetor do I need for a 350?
A 600-cfm carburetor may perform quite well on a stock 350 Chevy. However, the minute you start weaving in power adders like a hotter cam, a dual-plane performance intake manifold, and aluminum heads you’re going to need 700-750 cfm.
How do I identify Barry Grant carburetor?
Re: Identify Barry Grant Carburetor? According to my BG catalogue, there should be a one or two digit designation on each side of the rear accelerator pump squirter. For example on a General Competition 650 Race Demon, there would be a “GC” on the driver’s side of the squirter and “28” on the other side of it.
What is a 4150 style carburetor?
The 4150 carburetor was first introduced for the 1957-58 Ford Thunderbird. Often referred to simply as the “ double pumper,” the 4150 and 4150-style carburetors fuel-feed inlets and a second full metering block on the secondary side, giving it dual accelerator pumps.
How do I know if I have a 2 barrel carburetor?
Autolite 2 barrel tuning To identify your carb you need the Ford tag number which is stamped into a triangular shaped aluminum tag under one of the fuel bowl screws. The numbers on that tag are the carb identification number, the design code and the production date code.
How much is a carburetor rebuild kit?
How Much Does a Carburetor Rebuild Kit Cost? A carburetor rebuild kit usually costs around $50 to $250, depending on its brand and inclusions. Most rebuild kits are direct fit, so make sure to choose one that’s compatible with your vehicle.