Quick Answer: What Holley Carburetor Has The L-8896 Part#?

How do I tell what model Holley carburetor I have?

It’s like a “VIN” for your carburetor and should be hand-stamped on the front of the choke tower to the right of the vent tube on most typical Holley carbs. The list number typically is four to six digits long and may or may not have a suffix number behind it. The date code will be right below it.

What is a Dominator carburetor?

The original Dominator® took carburetion to another level in 1969 when it was developed for NASCAR® racing. Holley Dominator carburetors are designed specifically for making top end horsepower and torque in high end racing engines and are the perfect carburetor for the budget minded racer.

What’s the difference between Holley 4150 and 4160?

These two are very similar with the primary difference that the 4150 uses a thick metering block in both the primary and secondary while the 4160 is shorter in length and uses a thin, metering plate on the secondary side.

What jets come in a Holley 1050 Dominator?


You might be interested:  Readers ask: What Is A Carburetor Cover Called?

How do I know what CFM my carburetor is?

How to calculate Carburetor CFM. The formula for calculating how much CFM (cubic feet per minute) your engine requires is: CFM = Cubic Inches x RPM x Volumetric Efficiency ÷ 3456.

How do you read a date code on a Holley?

Moving on, 0798 is our date code; Holley used a three digit up to 1973, after which they moved to the four digit code you see here. Decoding them is as follows: Three Digit – Example 763 > 7 – Year (1967), 6 – Month (June), 3 – (Third Week)

Can you run a Dominator carb on the street?

Unless you’re packin’ at least 400 inches and 550 hp, a Dominator is not the carb of choice for a streeter. These are cavernous carburetors that will sacrifice throttle response and off-idle driveability in favor of max airflow. The bottom line is that large carburetors can be made to work on the street.

Is quick fuel made by Holley?

On December 8, 2014, Holley acquired DiabloSport Inc. The industry leader in vehicle calibration.

What carburetor did Ford use?

Ford trucks, Lincoln cars, Jeep and AMC continued to use Autolite four-barrels with a third generation carburetor referred to as the model 4350.

What CFM is a Holley 4150?

Holley 750 cfm 4150 HP Carburetor Kit Includes 750 CFM Carb – 30cc Accelerator Pumps.

What size carburetor do I need for a 350?

A 600-cfm carburetor may perform quite well on a stock 350 Chevy. However, the minute you start weaving in power adders like a hotter cam, a dual-plane performance intake manifold, and aluminum heads you’re going to need 700-750 cfm.

You might be interested:  Question: Where Is The Carburetor On A Atv?

Who makes Dominator carburetors?

Today, Holley has introduced the latest in a long line of Dominator carburetors, the Gen 3 model. The main-body has been raised 5/16” which allowed more area to better contour the venturi inlet. The new main body was also designed to allow for much larger CFM versions – all the way up to 1475 CFM, in fact.

How does a Holley power valve work?

The Holley power valve is a simple diaphragm with a tapered seat-valve that is exposed on the carb body side to intake manifold vacuum. With high manifold vacuum in a part-throttle situation, this low pressure “pulls” on the valve keeping it closed.

Leave a Reply

Your email address will not be published. Required fields are marked *