Quick Answer: How To Properly Adjust A Carburetor On Chainsaw?

What does the L and H mean on a chainsaw?

The letters on the screws represent High (H), Low (L) and Idle (T). The H screw regulates the Air/Fuel mix during high RPMs, while the L Screw does the same during low RPMs. This adjustment screw is responsible for adjusting the chainsaws idle.

How do you adjust the fuel mixture on a chainsaw?

Carburetor Adjustment Procedure

  1. Before you start the saw, locate a small flat-bladed screwdriver.
  2. Begin by checking the saw’s air filter.
  3. Check the fuel level.
  4. Start the engine and warm it up.
  5. Begin by setting the idle speed.
  6. Set the low speed fuel adjustment.
  7. Go back to step (4) and reset the idle speed.

Why does my chainsaw bog down when I give it gas?

If your chainsaw is bogging down when you give it throttle, this is often a sign of improper gas-to-oil ratio. If there is too much gasoline in relation to the amount of oil used, this is known as a “rich mixture” and can cause the chainsaw to run poorly.

How do I know if my carburetor is rich or lean?

Q: How Do You Tell if a Carburetor Is Rich or Lean? A: One way to tell for sure is by “reading” the spark plugs. If the plug tip is white, the mixture is lean. If it’s brown or black, it’s rich.

You might be interested:  Often asked: What Is The Difference Between A 2 Barrel And 4 Barrel Carburetor On A Boat?

How do you know if your chainsaw is running lean?

If your saw is running LEAN it will be doggy on acceleration, Have a white arond the exhaust and the spark plug will also be burning white in color.

What are the two adjustment screws on a carburetor?

Instructions. Locate the two adjustment screws on the carburetor. One screw is for the idle speed or low speed; the other is for the high speed. Turn both of the screws counterclockwise to back them out.

How do you adjust a running rich carburetor?

Regardless of whether or not the engine is running too rich or too lean, bring it down to a very lean mixture by turning both screws a quarter-turn at a time, counter-clockwise, then slowly bringing them back up to an equal and smooth mixture.

Why does my Stihl chainsaw bog down when I give it gas?

Without the right amount of air and fuel in the piston cylinder, the 2-cycle engine in a Stihl chain saw runs inefficiently and the saw loses power. When the saw bogs down during cutting, it’s usually the high-speed screw you need to adjust.

How do you reset the carburetor on a chainsaw?

How to Tune a Chainsaw Carburetor

  1. Start your saw and run it for a few minutes to warm it up.
  2. Set your saw down, let it idle for 30 seconds, and then pick it up and tip it forward (handle up and bar down).
  3. If it keeps running, go to Step 4.
  4. Rev (accelerate) the idling saw.
  5. If it accelerates fine, go to Step 6.

Leave a Reply

Your email address will not be published. Required fields are marked *