Question: What Size Is The Primary Jet On A 5210c Holley Carburetor?

Does main jet affect idle Holley?

As far as jetting goes, the jet size will not affect idle, as the jets don’t come into play until the carb transitions to the primary circuit, unless the throttle blades are open far enough to expose the transfer slot.

What thread size are Holley Jets?

Features: Main Jet Tap. 1/4-32 UNF Thread.

What size jets come in a Holley 750 double pumper?

I have noticed that it comes factory fitted with 73 jets on the Primary and Secondary.

Why is my Holley carb running rich?

If your engine is running rich and my mixture screws do not have effect: The first thing you need to check is your float level. No fuel should run from the sight hole unless you shake the vehicle. Next check the engine vacuum at idle. (in gear if A/T) if it is 12″ or more a 6.5″ power valve will usually be fine.

What happens if main jet is too big?

For example, using too large of a main jet will cause more fuel to enter the combustion chamber than it can efficiently burn. This will result in a “sputter” at full throttle. It could best be described as a rapid misfire.

You might be interested:  Often asked: How To Clean Carburetor On Husqvarna Chainsaw 235?

Does main jet affect idle?

The main jet does not effect the jetting for starting and idling. It plays no part on low RPM or mid RPM jetting either.

Do primary jet affect idle?

main jet has no effect on idle. you can remove the main jet completely and it will still idle just like it did.

Can you drill out carb jets?

By drilling out your stock main jet to larger sizes you will be able to narrow down what jet size your carburetor needs. You will need a numbered drill bit set. If it’s lean and you need to increase the size of your main jet, drill the jet out with the next size larger drill bit, which in this case is the #60 bit.

Are Holley and quick fuel jets the same?

The jets, PV and air bleeds are all the same as Holley.

Leave a Reply

Your email address will not be published. Required fields are marked *