Question: How To Clean A Husqvarna 125 Weed Eater Carburetor?

Why does my Husqvarna Trimmer won’t stay running?

If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor. The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving fuel in the string trimmer for a long period of time.

How do you clean a carburetor without removing it?

Spray liberally with carb cleaner – trying to direct the cleaner into the jets – and leave to soak for a few minutes. Use an air line (or a can of pressurised air, sold as an ‘air duster’) to blow through the jets. Repeat the previous step and this one until you can see no more gunge.

Why does my Ryobi weed eater won’t stay running?

When your Ryobi weed wacker won’t stay running, the problem is usually based on fuel or airflow and can be solved by either adjusting the carburetor or replacing any damaged parts that make up the fuel system. A carburetor rebuild, fuel intake adjustment, or part replacement can solve the problem.

Why does my weed eater keep dies when I give it gas?

Why does my weed eater die when giving it gas? The most common causes of a weed eater dying when throttled are fuel issues, insufficient air intake, or problems with the exhaust. You should follow the path that the fuel travels to identify the issue.

You might be interested:  Often asked: How To Adjust The Carburetor On My 13 Hp Chinese Generator?

Why does my Stihl weed eater keep dying?

One reason why one of these trimmers may die at full throttle is that too much oil is in the gas, which causes poor combustion. Improper operation, including overuse of the choke, can also be responsible. Poor combustion produces carbon deposits that foul the spark plug and exhaust port, making the problem worse.

Why do I have to run my weed eater on half choke?

When your trimmer starts and runs on choke, it could be because the check valve in the gas cap is clogged. Start the trimmer and gently unscrew the gas cap halfway off. Turn the choke off and assess. If the engine is still running, that means the gas cap may be the culprit.

How do you adjust a carburetor on a Husqvarna?

Method for Adjusting the Carburetor Start the saw and adjust the L screw by turning it clockwise until the engine almost stops. Turn it counterclockwise until the engine starts running smoothly and then check the adjustment by squeezing the throttle trigger and noting a smooth acceleration of the engine as you do this.

Leave a Reply

Your email address will not be published. Required fields are marked *