Question: How To Change Carburetor On 2004 Honda Rancher Site:Youtube.Com?

How do you remove the carburetor on a Honda Rancher 350?

Clean the Carburetor on a Honda TRX 350 Rancher

  1. Remove the airbox by loosening the two clamps on its sides, then removing the crankcase breather hose and the 10mm bolt beneath the airbox.
  2. Remove the carburetor by loosening the clamp on the carburetor intake and taking off the intake pipe.

How do you adjust the carburetor on a Honda ATV?

How do I Adjust a Carb on a Honda 300EX ATV?

  1. Locate the carburetor on the top middle of the engine. Turn the gas valve to the off position.
  2. Turn the air valve screw clockwise until the head of the screw touches the frame of the carburetor. Turn the air valve counterclockwise three full turns.

What are the steps to cleaning a carburetor?

Directions for How To Clean A Carburetor:

  1. Dilute cleaner. In a large container, mix 1 part Simple Green Pro HD Heavy-Duty Cleaner to 3 parts water.
  2. Clear air filter.
  3. Remove the carburetor.
  4. Remove carburetor float.
  5. Remove other removable components.
  6. Soak and scrub components.
  7. Rinse and dry.
  8. Reassemble and replace.
You might be interested:  Where Does The Pcv Valve Hook To The Carburetor?

How do you clean ATV carburetor without taking it off?

Here’s the process:

  1. Safety checks.
  2. Move the bike to a clean, clear bit of floor.
  3. Drape a plain-coloured cloth over the casings below the carb.
  4. Drain the float bowls.
  5. Remove the float bowl, often held on by four crosshead screws.
  6. Remove the float – it’s held in place by a small pin that can just be pushed out.

How do you remove a throttle cable from an ATV carburetor?

Open the throttle fully by hand so the cable is loose. There is a slotted brass piece that traps the end of the cable. With the cable loose enough the brass piece comes out towards you and the cable slips out of the brass piece(don’t lose it). You can then unscrew the cable from the carb and pull it out.

How do you adjust the air fuel mixture on an ATV?

Make adjustments 1/2 a turn in either direction to find the smoothest idle speed. Turn the screw counterclockwise and clockwise 1/2 a turn from the middle position and listen to the sound of the idle. Set the screw in the position where the engine’s idle sounds most even and smooth to balance the fuel mixture.

Why does my 4 wheeler bogs down when I give it gas?

The most common reason when an ATV bogs down when giving gas is a dirty air filter and/or carburetor. This happens when the ATV is continuously used after some time. Fixing these issues is easy – clean the air filter and/or check and adjust the carburetor.

You might be interested:  FAQ: How To Adjust Shovelhead Carburetor?

How do you know if your ATV is running lean or rich?

A black dry fluffy colored plug is caused by deposits from a carburetor that is running too rich (too much gas), or excessive idling on some engines. Black smoke coming from the exhaust is a sign of a rich air/fuel mixture.

Leave a Reply

Your email address will not be published. Required fields are marked *