- 1 How do you adjust a craftsman carburetor?
- 2 Why does my Craftsman weed eater dies when I give it gas?
- 3 How do you adjust a carburetor?
- 4 How do you adjust the idle screw on a weed eater?
- 5 What size string does a Craftsman weed eater use?
- 6 How do you adjust a high and low carburetor?
- 7 Why does my Craftsman chainsaw bog down?
- 8 Why does my chainsaw dies when I give it gas?
How do you adjust a craftsman carburetor?
How to Adjust a Carburetor in a Craftsman
- Locate the carburetor on your Craftsman equipment.
- Turn the main mixture and idle mixture screws on the carburetor counterclockwise about one full turn with a flat-head screwdriver.
- Start the engine with the transmission in neutral and let it run for several minutes.
Why does my Craftsman weed eater dies when I give it gas?
Sometimes a weed eater will start, and even idle just fine, but when you give it gas, it dies. This is often a sign that the engine is struggling to get sufficient amounts of either fuel or air.
How do you adjust a carburetor?
Here’s How To Adjust a Carburetor
- Remove the Engine Air Filter. The air cleaner and filter assembly must be removed for you to access the carburetor.
- Locate Adjustment Screws.
- (Optional): Hook up Vacuum Gauge.
- (Optional): Set Baseline.
- Warm the Engine Up.
- (Optional): Adjust Idle Speed Screw.
- Adjust the Air-Fuel Mixture.
How do you adjust the idle screw on a weed eater?
How to Adjust the Idle on a Weed Eater
- Place the Weed Eater trimmer on a workbench or other flat surface.
- Locate the idle speed adjustment screw situated to the side and slightly behind the air filter.
- Turn the adjustment screw to the right, or clockwise, to increase the engine idle speed.
What size string does a Craftsman weed eater use?
Your trimmer requires 0.110 line. The correct line comes in a package of precut line.
How do you adjust a high and low carburetor?
Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.
Why does my Craftsman chainsaw bog down?
If your chainsaw is bogging down when you give it throttle, this is often a sign of improper gas-to-oil ratio. If there is too much gasoline in relation to the amount of oil used, this is known as a “rich mixture” and can cause the chainsaw to run poorly.
Why does my chainsaw dies when I give it gas?
Because your chainsaw will idle, but dies when it is revved up to full power, it means that the filter is only partially clogged; it will allow enough fuel to the engine to run on idle, but not enough to sustain full throttle. If the filter becomes clogged, not enough fuel will reach the engine for it to run properly.