Question: How To Adjust Redmax Gz380 Chainsaw Carburetor Video?

How do you adjust H and L screws on a carburetor?

Set the idle speed screw(not L or H) so it is just able to idle by itself. This screw will have a “stop” it rests against. Now turn the L screw out until in decreases in rpm and then back in(very slowly) until it is at peak rpm. Adjust the H screw once more as above and it should be a very serviceable 2 stroke.

Why does my chainsaw bog down when I give it gas?

If your chainsaw is bogging down when you give it throttle, this is often a sign of improper gas-to-oil ratio. If there is too much gasoline in relation to the amount of oil used, this is known as a “rich mixture” and can cause the chainsaw to run poorly.

Why does my Poulan chainsaw dies when I give it gas?

The fuel filter might be clogged. A clogged fuel filter is often caused by leaving old fuel in the chainsaw. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and cause the engine to stall.

You might be interested:  Readers ask: How To Adjust The Mixture + 594593 Carburetor For Briggs Stratton?

What are the two adjustment screws on a carburetor?

Instructions. Locate the two adjustment screws on the carburetor. One screw is for the idle speed or low speed; the other is for the high speed. Turn both of the screws counterclockwise to back them out.

How do you adjust the carburetor mixture on a screw?

Locate the idle mixture screw and turn it clockwise until the needle lightly touches the seat. Then, turn the screw counterclockwise 1-1/2 turns. If your carburettor has a main jet adjustment screw at the base of the float bowl, turn the screw clockwise until you feel it just touch the seat inside the emulsion tube.

How do you adjust the carburetor on a chainsaw?

How to Tune a Chainsaw Carburetor

  1. Start your saw and run it for a few minutes to warm it up.
  2. Set your saw down, let it idle for 30 seconds, and then pick it up and tip it forward (handle up and bar down).
  3. If it keeps running, go to Step 4.
  4. Rev (accelerate) the idling saw.
  5. If it accelerates fine, go to Step 6.

How do you adjust the high and low on a Poulan chainsaw?

High and Low Speed Adjustments Start the chain saw as you normally do and let it idle, making sure the chain does not touch anything. Insert a small flat-head screwdriver into the idle speed screw and turn it clockwise to increase the engine speed if it idles too slowly.

Why does my chainsaw only runs on choke?

If your chainsaw only runs with the choke on, it is likely an issue with your carburetor. If the carburetor is plugged, the engine will be starved of fuel and will not run. However, if the engine is plugged, the choke will pull more fuel through the carburetor’s idle circuit and allow it to run.

Leave a Reply

Your email address will not be published. Required fields are marked *