- 1 How do you adjust a Troy-Bilt Tiller?
- 2 Why won’t my Troy-Bilt tiller stay running?
- 3 How do you adjust a carburetor?
- 4 How do you adjust the belt on an old Troy-Bilt Tiller?
- 5 How do I tell what year my Troy-Bilt tiller is?
- 6 Why is my tiller not stay running?
- 7 How do you fix a tiller that won’t start?
- 8 Does carburetor cleaner work?
How do you adjust a Troy-Bilt Tiller?
Shift the Wheels/Tines/PTO lever to the forward position. Hold the Wheels/Tines/PTO lever in the forward position as you loosen the bolt on the back of the upright lever with a 5/8-inch bolt. Do not remove the bolt; just loosen it. Push the lever down if the belt is loose or pull the lever up if the belt is too tight.
Why won’t my Troy-Bilt tiller stay running?
Troy-Bilt Small engine stops after a few seconds The carburetor might be clogged. This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.
How do you adjust a carburetor?
Here’s How To Adjust a Carburetor
- Remove the Engine Air Filter. The air cleaner and filter assembly must be removed for you to access the carburetor.
- Locate Adjustment Screws.
- (Optional): Hook up Vacuum Gauge.
- (Optional): Set Baseline.
- Warm the Engine Up.
- (Optional): Adjust Idle Speed Screw.
- Adjust the Air-Fuel Mixture.
How do you adjust the belt on an old Troy-Bilt Tiller?
Shift the wheels/tines/PTO drive lever to the forward setting and hold it there. At the same time, loosen the 9/16 -inch bolt on the back of the belt adjustment block enough that the belt adjustment block slides up and down.
How do I tell what year my Troy-Bilt tiller is?
To locate the serial number on the tillers themselves to determine the age of the unit, look for the tab on the side of the transmission, near the top, behine the right wheel from the right hand of the operator’s position.
Why is my tiller not stay running?
If your tiller engine isn’t running smoothly, cleaning or replacing the carburetor, tuning up the engine or replacing bad gas may fix the problem. Replace the carburetor if it’s too clogged to clean. Tune up the tiller engine by replacing the spark plug and oil. A dirty spark plug won’t ignite the fuel properly.
How do you fix a tiller that won’t start?
Bad gasoline can clog the carburetor, so clean and rebuild the carburetor if the tiller doesn’t start after replacing the gas in the fuel tank. Replace the carburetor if it’s too clogged to clean. A dirty spark plug won’t ignite the fuel to start the engine.
Does carburetor cleaner work?
Most carburetor cleaners do the work for you, no scrubbing required. Readily available and affordable. Most auto parts stores will carry a few brands of carburetor cleaner. Typically less than $20, carburetor cleaners are a cheap, efficient way to improve the overall performance of your vehicle.