Question: How To Adjust Carburetor On Stihl Trimmr?

How do you adjust the idle on a Stihl weedeater?

How to Adjust the Idle on a Weed Eater

  1. Place the Weed Eater trimmer on a workbench or other flat surface.
  2. Locate the idle speed adjustment screw situated to the side and slightly behind the air filter.
  3. Turn the adjustment screw to the right, or clockwise, to increase the engine idle speed.

Is it illegal to own a carburetor adjustment tool?

it is illegal by EPA regulations to sell carburetor adjusting tools and illegal to buy them unless you are a servicing dealer.

How do I reset my Stihl carburetor?

Return a type A carburetor to its factory setting by turning the “H” screw counterclockwise until it stops, turning the “L” screw clockwise until it is seated, then backing it off one full turn.

Should trimmer head spins at idle?

A string trimmer uses the same clutch mechanism as a chainsaw to prevent the working part of the tool from spinning when the engine is idling. If the clutch isn’t working properly and the string won’t stop turning, the tool can be dangerous — it could damage something or even cause injury.

How do you adjust a high and low carburetor?

Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.

You might be interested:  How To Repair Lawn Boy Carburetor?

What is the H and L on a carburetor?

They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).

How do you adjust carb screws?

Set the idle screw so that the engine is idling at a normal RPM. Take a small screwdriver and start turning one bleeder screw on one side of the carb inward until the idle either drops or rises. If it drops, you are going the wrong way, so turn it the other way until the you hear the engine’s idle rise back up again.

How do you adjust air and fuel mixture?

Turn the screw clockwise until the engine starts to sound rough.

  1. Tightening the screw weakens the air and fuel mixture and decreases the amount of fuel flowing to the engine.
  2. Tightening the screw is also called making the fuel mixture leaner, which lowers the RPMs at which the engine idles.

Why does my trimmer keeps stalling?

A clogged fuel filter is most commonly caused by leaving fuel in the string trimmer for a long period of time. This sticky fuel can clog up the fuel filter and cause the engine to stall. If old fuel was left in the string trimmer, drain the old fuel from the fuel tank and replace the fuel filter.

Leave a Reply

Your email address will not be published. Required fields are marked *