- 1 How do you adjust a craftsman carburetor?
- 2 How do you adjust a high and low carburetor?
- 3 How do you adjust a carburetor?
- 4 Why does my Craftsman chainsaw bog down?
- 5 Why does my Ryobi weed eater won’t stay running?
- 6 Why does my Ryobi stop running?
- 7 What is the fuel mixture for a Ryobi weed eater?
- 8 How do you adjust the idle screw on a weed eater?
How do you adjust a craftsman carburetor?
How to Adjust a Carburetor in a Craftsman
- Locate the carburetor on your Craftsman equipment.
- Turn the main mixture and idle mixture screws on the carburetor counterclockwise about one full turn with a flat-head screwdriver.
- Start the engine with the transmission in neutral and let it run for several minutes.
How do you adjust a high and low carburetor?
Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.
How do you adjust a carburetor?
Here’s How To Adjust a Carburetor
- Remove the Engine Air Filter. The air cleaner and filter assembly must be removed for you to access the carburetor.
- Locate Adjustment Screws.
- (Optional): Hook up Vacuum Gauge.
- (Optional): Set Baseline.
- Warm the Engine Up.
- (Optional): Adjust Idle Speed Screw.
- Adjust the Air-Fuel Mixture.
Why does my Craftsman chainsaw bog down?
If your chainsaw is bogging down when you give it throttle, this is often a sign of improper gas-to-oil ratio. If there is too much gasoline in relation to the amount of oil used, this is known as a “rich mixture” and can cause the chainsaw to run poorly.
Why does my Ryobi weed eater won’t stay running?
When your Ryobi weed wacker won’t stay running, the problem is usually based on fuel or airflow and can be solved by either adjusting the carburetor or replacing any damaged parts that make up the fuel system. A carburetor rebuild, fuel intake adjustment, or part replacement can solve the problem.
Why does my Ryobi stop running?
This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving fuel in the string trimmer for a long period of time.
What is the fuel mixture for a Ryobi weed eater?
Ratios. You can make a 50:1 fuel ratio by mixing one gallon of unleaded gasoline — rated at least 87 octane — with 2.6 ounces of two-cycle oil in a container approved for storing gasoline. First pour the oil in the container; then add the gasoline.
How do you adjust the idle screw on a weed eater?
How to Adjust the Idle on a Weed Eater
- Place the Weed Eater trimmer on a workbench or other flat surface.
- Locate the idle speed adjustment screw situated to the side and slightly behind the air filter.
- Turn the adjustment screw to the right, or clockwise, to increase the engine idle speed.