- 1 What causes a lawn mower engine to rev up and down?
- 2 Can Governor cause surging?
- 3 Why is my mower engine surging?
- 4 Can bad spark plugs cause engine surging?
- 5 What causes a carbureted engine to surge?
- 6 How do you adjust the fuel mixture on a Briggs and Stratton?
- 7 What causes a 2 cycle engine to surge?
- 8 Can valves cause surging?
What causes a lawn mower engine to rev up and down?
A lawnmower that hunts and surges may be experiencing something as simple as an airflow issue. If the air that the engine requires to run is blocked, especially sporadically, it can cause the engine to slow down. When the blockage moves or clears, the engine may suddenly rev up in response.
Can Governor cause surging?
If the spring is set in the wrong position it can cause the engine RPMs to surge. Over time the spring can stretch out, causing the same engine surging. Often surging caused by the governor can be fixed by simply adjusting the governor spring. It usually only takes a small adjustment to correct the surging.
Why is my mower engine surging?
Problems in the Fuel System Check and clean the vent. Surging is also caused by water that got into the fuel. A mower left in a heavy rain or condensation on a hot summer day can choke the engine. Empty the gas tank, properly dispose of the old fuel and try a fresh batch of gasoline.
Can bad spark plugs cause engine surging?
3. Surging and Lagging. Another good indication that your spark plugs are dirty or worn is if your vehicle experiences surges of speed, resulting in a jerking acceleration. These surges occur because your spark plugs are not igniting the fuel in your engine at the proper rate, resulting in an uneven speed.
What causes a carbureted engine to surge?
If an engine is not getting enough fuel (this is called “running lean”), due to fuel pressure (regulated by the fuel pump and regulator), restricted fuel injectors, a vacuum leak or really anything that throws off the fuel mixture going in to the engine, this can cause the surge.
How do you adjust the fuel mixture on a Briggs and Stratton?
Locate the idle adjustment screw on the side of the carburetor. It sometimes has a spring wound around the shaft. Turn this screw clockwise with a Phillips screwdriver until you encounter resistance, which means it has contacted the carburetor seat. Back it off 1 to 1 1/2 turns.
What causes a 2 cycle engine to surge?
The most common causes of a two-stroke engine surging include lack of airflow, contaminated fuel, faulty or old spark plugs, or a maladjusted carburetor. Fixing each of these issues involves removing parts of the engine, inspecting, and possibly replacing the equipment.
Can valves cause surging?
Surges are almost always caused by a rapid change in fluid velocity within a pipeline or network of pipes. Pumps, control valves and equipment failure often can be the cause of surges. However, with some equipment, including pumps and control valves, a more effective means to handle surges is required.