What are the carburetor settings on a Mantis Tiller?
The Mantis tiller carburetors are adjusted using a red and a white screw located behind the air filter cover near the black choke button on the right side of the engine. The red screw adjusts the high-speed setting and the white screw controls the low-speed setting.
Why is my Mantis tiller smoking?
4-stroke Mantis tiller: my machine smokes, there is too much oil in it, how do I clean it? If your machine smokes, if oil flows through the air filter or of the rope is blocked, there is too much oil in the machine. Sometimes, when the machine does not start, it can also be because of an excess of oil in the reservoir.
How do you start a flooded Mantis Tiller?
Pull the choke button all the way out. Pull the cord three or four times, and the engine should sputter. Push the choke button in and pull the cord. After a few pulls, the engine should start and run.
How do you check a Mantis Tiller ignition coil?
Slide the boot on the plug, hold it against the block and pull it like you mean it. You should have a fat blue spark. If it’s dull yellow after all that it’s new coil time.
How do you adjust a carburetor?
Here’s How To Adjust a Carburetor
- Remove the Engine Air Filter. The air cleaner and filter assembly must be removed for you to access the carburetor.
- Locate Adjustment Screws.
- (Optional): Hook up Vacuum Gauge.
- (Optional): Set Baseline.
- Warm the Engine Up.
- (Optional): Adjust Idle Speed Screw.
- Adjust the Air-Fuel Mixture.
What is the H and L on a carburetor?
They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).
What oil do you use for Mantis Tiller?
Your Mantis Tiller is powered by a commercial two stroke, air cooled engine which requires a fuel mixture of unleaded petrol and lubri- cating oil. Use a mixture of 50 parts unleaded regular petrol and 1 part two- stroke Mantis oil (50:1).