What is the H and L on a carburetor?
They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).
How do you adjust the carburetor on a Husqvarna trimmer?
Adjust the idle speed by inserting the screwdriver into the hole marked “T.” Turn the screw in clockwise until the trimmer head starts to rotate. Turn the screw back in ¼ increments until the cutting head stops spinning. Readjust the screw marked “L” to fine tune for the optimum engine performance.
Why does my trimmer line run out so fast?
Here’s why, over feeding the string will waste a lot of string, if you keep tapping, it keeps coming out, and getting cut by the blade on your trimmer head. You could literally run out of string by just feeding more string too often. Practice feeding, only when you need it. 7
How do you reset a carburetor?
If the carburetor is new or has been rebuilt, you should set it to “factory” adjustment. You can do so by adjusting the idle mixture screws to 1.5-2 turns out, and the idle speed screw to 1-1.5 turns in. Warm the Engine Up. The engine’s running temperature directly correlates with proper air and fuel mixtures.
How do you adjust a carburetor on a small engine?
Turn the high speed or main jet screw clockwise until the engine begins to slow. Then, turn the screw the other way until the engine begins to slow. Turn the screw back to the midpoint. Once adjusted, check engine acceleration by moving the throttle from idle to fast.
Is Thicker trimmer line better?
String Trimmer Line Thickness This probably comes as no surprise to anyone, but the general rule with string trimmer line is that the tougher the application, the thicker the line needs to be. A larger diameter will increase the power and durability of the line, which leads to less breakage and wear-out.
How long should my trimmer line be?
Length With Guard On Every trimmer is different but essentially, the length of the wire will be dictated by the guard. There should be a marker on the guard that shows you where the wire should come to. Some trimmers have a length requirement of as little as ten inches whereas others might go up to 25 inches.