Often asked: How To Adjust Carburetor On Sthil 660?

How do you adjust a Stihl carburetor?

Start the trimmer and hold the throttle trigger in all the way to get the trimmer head spinning at maximum speed. Turn the H screw clockwise with a carburetor adjustment tool until the head is spinning as fast as it will go, then back off the screw carefully until the RPMs start to decrease.

How do you adjust H and L screws on a carburetor?

Set the idle speed screw(not L or H) so it is just able to idle by itself. This screw will have a “stop” it rests against. Now turn the L screw out until in decreases in rpm and then back in(very slowly) until it is at peak rpm. Adjust the H screw once more as above and it should be a very serviceable 2 stroke.

Why does my chainsaw dies when I give it gas?

Because your chainsaw will idle, but dies when it is revved up to full power, it means that the filter is only partially clogged; it will allow enough fuel to the engine to run on idle, but not enough to sustain full throttle. If the filter becomes clogged, not enough fuel will reach the engine for it to run properly.

You might be interested:  Readers ask: How To Tune An Older Carburetor?

How do you adjust the high and low on a Stihl chainsaw?

They are the high-speed, low-speed and idle adjustments respectively. Determine the carburetor type before adjusting the high- and low-speed screws. To do this, turn the “L” screw clockwise as far as it will go, using a flat-head screwdriver, then turn it counterclockwise as far as it will go.

How do you adjust a rich carburetor?

Regardless of whether or not the engine is running too rich or too lean, bring it down to a very lean mixture by turning both screws a quarter-turn at a time, counter-clockwise, then slowly bringing them back up to an equal and smooth mixture.

Why does my chainsaw bogs down at full throttle?

If your chainsaw is bogging down when you give it throttle, this is often a sign of improper gas-to-oil ratio. If there is too much gasoline in relation to the amount of oil used, this is known as a “rich mixture” and can cause the chainsaw to run poorly.

What is the H and L on a carburetor?

They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).

How do you adjust the air fuel mixture in a carb?

Carb Quick Guide

  1. Verify carburetor is set to stock settings:
  2. Start bike, bring to operating temperature.
  3. Set idle speed adjusting screw, clockwise to increase rpm, counter-clockwise to decrease rpm.
  4. Adjust idle mixture by turning idle mixture screw slowly clockwise until the engine runs poorly.

What are the two adjustment screws on a carburetor?

Instructions. Locate the two adjustment screws on the carburetor. One screw is for the idle speed or low speed; the other is for the high speed. Turn both of the screws counterclockwise to back them out.

You might be interested:  Readers ask: What If Engine Oil Smells Like Gas Carburetor Engine?

How do you adjust a high and low carburetor?

Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.

How do you adjust the air screws on a carburetor?

Turn the screw counterclockwise and clockwise 1/2 a turn from the middle position and listen to the sound of the idle. Set the screw in the position where the engine’s idle sounds most even and smooth to balance the fuel mixture.

Leave a Reply

Your email address will not be published. Required fields are marked *