Often asked: How Much Would It Cost To Tune Up A 2002 883cc Sportster Carburetor?

How can I get more power out of my 1200 Sportster?

How to Get More Power Out of a Sportster 1200

  1. Replace the stock air intake system. The factory-equipped air intake system is restrictive, allowing a smaller amount of air into the carburetor.
  2. Replace the stock exhaust system.
  3. Rejet the carburetor.
  4. Replace the stock drive (front) pulley.

How much HP can a 1200 Sportster make?

We documented 59.14 hp at 5,410 rpm and 67.08 pound-feet of torque at 4,050 rpm. Compared to the standard Iron equipped with the 883cc Evolution v-twin engine, which was first introduced in 2009, the Iron 1200 produced 12.44 more hp and 18.18 additional pound-feet of torque.

Is it expensive to maintain a Harley Davidson?

Harley Davidson is a brand of motorcycles that most riders generally hope they can own in their lifetime. It should not be a surprise that the Ultra Classic makes the list of one of the most expensive bikes to maintain.

Are Harleys easy to fix?

Harleys are easy to work on That means you might not need help from those dealers and indie mechanics. Newer Harleys typically have very long service intervals, and while older Harleys tend to need lots of attention, it’s usually very easy to give. Those are a few of my reasons for keeping a Harley in the stable.

You might be interested:  Readers ask: What Is The Starting Point For A Ryobi String Trimmer Carburetor?

How do you get 100 horsepower out of a 1200 Sportster?

How to Get 100 HP From a 1200 Sportster

  1. Establish a game plan and purchase necessary parts.
  2. Remove the engine from the frame and remove the old heads, cylinders and pistons.
  3. Install new pistons, ensuring that piston pin clips are installed properly and pistons are facing the correct direction.
  4. Install the new heads.

Are 1200 Sportsters fast?

Top Speed. Motorcycle.com tested the 2011 model XR1200R Sportster, and the top speed attained by the bike was 122 mph. Older versions of the Sportster don’t attain this speed. The 2001 Sportster 1200 Customs have a top speed of 106.9 mph.

Can you clean a motorcycle carburetor without removing it?

To clean a motorcycle carburetor without removing it, you’ll need to remove the bowls at the bottom of the carburetor. Once the bowls are removed, spray some carburetor cleaner up inside, wait a few minutes, then spray again to ensure coverage. Then replace the bowls and start the motorcycle to assess how it runs.

How do you know if your carburetor needs cleaning?

4 Signs Your Carburetor Needs Cleaning

  1. It just won’t start. If your engine turns over or cranks, but doesn’t start, it could be due to a dirty carburetor.
  2. It’s running lean. An engine “runs lean” when the balance of fuel and air gets thrown off.
  3. It’s running rich.
  4. It’s flooded.

What can I use to clean my carburetor jets?

We’ve tried spraying carb cleaner and a vinegar soak, both with mixed results. A solution of pure lime juice or lemon juice turns out to work the best. Not only does it remove any remaining toilet cleaner residue, but it also leaves your jets smelling great. After the soak, dry the parts using compressed air.

You might be interested:  Quick Answer: How To Clean Out A Small Engine Carburetor?

Whats the biggest engine you can put in a Sportster?

1450 – 1550 cc is the biggest you can go using stock cases.

How much power can a Sportster make?

According to the dynojet screenshot, the 883 Sportster in its stock shape delivered a maximum of 45.4 horsepower, whereas the 1250 Big Bore Kit provided 99.7 hp. The rear wheel torque went up from 47.3 lb-ft (64.2 Nm) to 81.6 lb-ft (110.7 Nm).

How much is 1200cc in horsepower?

“Out of the box,” the horsepower rating on the V-twin 1200 is 66, placing it in the “cruiser” category.

Leave a Reply

Your email address will not be published. Required fields are marked *