How To Adjust Carburetor On Troy Bilt Weed Eater?

How do you adjust the idle on a weed eater?

How to Adjust the Idle on a Weed Eater

  1. Place the Weed Eater trimmer on a workbench or other flat surface.
  2. Locate the idle speed adjustment screw situated to the side and slightly behind the air filter.
  3. Turn the adjustment screw to the right, or clockwise, to increase the engine idle speed.

What causes a weed eater to bog down?

The most common causes of a weed eater dying when throttled are fuel issues, insufficient air intake, or problems with the exhaust. You should follow the path that the fuel travels to identify the issue.

Is it illegal to own a carburetor adjustment tool?

it is illegal by EPA regulations to sell carburetor adjusting tools and illegal to buy them unless you are a servicing dealer.

How do you adjust a high and low carburetor?

Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.

Should trimmer head spins at idle?

A string trimmer uses the same clutch mechanism as a chainsaw to prevent the working part of the tool from spinning when the engine is idling. If the clutch isn’t working properly and the string won’t stop turning, the tool can be dangerous — it could damage something or even cause injury.

You might be interested:  Quick Answer: How To Clean Golf Cart Walbor Carburetor?

How do you adjust the carburetor on a Featherlite weed eater?

Adjust the Carburetor on a Weedeater Featherlite

  1. Adust both screws clockwise until just tight using the correct tool.
  2. Rotate the HI screw one and a half full turns counter-clockwise.
  3. Rotate the LO screw one full turn counter-clockwise.
  4. Open the choke by pulling the choke level all the way out or turning it to full.

Leave a Reply

Your email address will not be published. Required fields are marked *