- 1 How do you adjust the carburetor on a Ryobi weed eater?
- 2 Why does my Craftsman weed eater dies when I give it gas?
- 3 How do you adjust a high and low carburetor?
- 4 Why does my Ryobi weed eater won’t stay running?
- 5 Why does my Ryobi stop running?
- 6 Can’t get Ryobi weed eater started?
- 7 How do you adjust the idle screw on a weed eater?
- 8 How do you adjust a two cycle carburetor?
How do you adjust the carburetor on a Ryobi weed eater?
Press the throttle trigger, and turn the high speed knob counterclockwise until the engine begins to run unevenly. Let go of the trigger, and allow the engine to idle. Press the trigger again, and slowly turn the high speed adjustment until the engine starts to run evenly.
Why does my Craftsman weed eater dies when I give it gas?
Sometimes a weed eater will start, and even idle just fine, but when you give it gas, it dies. This is often a sign that the engine is struggling to get sufficient amounts of either fuel or air.
How do you adjust a high and low carburetor?
Locate the two fuel-adjustment screws on the side of the carburetor. One will be labeled “Hi” and the other “Lo.” The “Hi” screw regulates the engine at full throttle and the “Lo” regulates the fuel when the engine is idling.
Why does my Ryobi weed eater won’t stay running?
When your Ryobi weed wacker won’t stay running, the problem is usually based on fuel or airflow and can be solved by either adjusting the carburetor or replacing any damaged parts that make up the fuel system. A carburetor rebuild, fuel intake adjustment, or part replacement can solve the problem.
Why does my Ryobi stop running?
This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving fuel in the string trimmer for a long period of time.
Can’t get Ryobi weed eater started?
Among the first things to check if your trimmer won’t start is the spark plug. In some cases, the spark plug may simply be dirty and need a thorough cleaning. To clean your spark plug, disconnect it and clean the area around it before removing it. Use a wire brush and a spray-on plug cleaner to scrape off the deposits.
How do you adjust the idle screw on a weed eater?
How to Adjust the Idle on a Weed Eater
- Place the Weed Eater trimmer on a workbench or other flat surface.
- Locate the idle speed adjustment screw situated to the side and slightly behind the air filter.
- Turn the adjustment screw to the right, or clockwise, to increase the engine idle speed.
How do you adjust a two cycle carburetor?
How to Adjust the Carburetor on a Small Two-Stroke Engine
- Locate the two adjustment screws on the carburetor.
- Turn both of the screws counterclockwise to back them out.
- Turn each screw clockwise two full turns.
- Start the engine and let it warm up for a minute or two.