- 1 What is the H and L on a carburetor?
- 2 How do you adjust H and L screws on a carburetor?
- 3 Why does my chainsaw dies when I give it gas?
- 4 How do I get my chainsaw to idle?
- 5 How do you reset a carburetor?
- 6 How do you adjust the high and low on a Stihl chainsaw?
- 7 What are the two adjustment screws on a carburetor?
- 8 Why does my Stihl chainsaw bog down when I give it gas?
- 9 Why does my chainsaw keep stopping?
What is the H and L on a carburetor?
They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).
How do you adjust H and L screws on a carburetor?
Set the idle speed screw(not L or H) so it is just able to idle by itself. This screw will have a “stop” it rests against. Now turn the L screw out until in decreases in rpm and then back in(very slowly) until it is at peak rpm. Adjust the H screw once more as above and it should be a very serviceable 2 stroke.
Why does my chainsaw dies when I give it gas?
Because your chainsaw will idle, but dies when it is revved up to full power, it means that the filter is only partially clogged; it will allow enough fuel to the engine to run on idle, but not enough to sustain full throttle. If the filter becomes clogged, not enough fuel will reach the engine for it to run properly.
How do I get my chainsaw to idle?
First set the idle speed by setting it as high as possible without engaging the clutch (close to 2700 RPM if you have a tachometer). Then set the low-speed screw by turning it gently in until the engine begins to starve for fuel, then turn it out gently until the engine loads up.
How do you reset a carburetor?
If the carburetor is new or has been rebuilt, you should set it to “factory” adjustment. You can do so by adjusting the idle mixture screws to 1.5-2 turns out, and the idle speed screw to 1-1.5 turns in. Warm the Engine Up. The engine’s running temperature directly correlates with proper air and fuel mixtures.
How do you adjust the high and low on a Stihl chainsaw?
They are the high-speed, low-speed and idle adjustments respectively. Determine the carburetor type before adjusting the high- and low-speed screws. To do this, turn the “L” screw clockwise as far as it will go, using a flat-head screwdriver, then turn it counterclockwise as far as it will go.
What are the two adjustment screws on a carburetor?
Instructions. Locate the two adjustment screws on the carburetor. One screw is for the idle speed or low speed; the other is for the high speed. Turn both of the screws counterclockwise to back them out.
Why does my Stihl chainsaw bog down when I give it gas?
Without the right amount of air and fuel in the piston cylinder, the 2-cycle engine in a Stihl chain saw runs inefficiently and the saw loses power. When the saw bogs down during cutting, it’s usually the high-speed screw you need to adjust.
Why does my chainsaw keep stopping?
The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. This sticky fuel can clog up the fuel filter and cause the engine to stall. If old fuel was left in the chainsaw, drain the old fuel from the fuel tank and replace the fuel filter.