- 1 Are Homelite chainsaws any good?
- 2 How do you adjust the carburetor on a Homelite chainsaw?
- 3 Where do the fuel lines go on a Homelite chainsaw?
- 4 Which fuel line goes to the primer bulb?
- 5 What is the fuel mixture for a Homelite chainsaw?
- 6 How do you test a Homelite chainsaw coil?
- 7 How do I start my Homelite chainsaw?
Are Homelite chainsaws any good?
The Homelite brand has a reputation for delivering affordable, functional tools with average homeowners in mind. This is on full display with the Homelite UT43122B electric chainsaw. It’s a good choice for occasional use and can handle pretty much any cutting job that’s likely to pop up around the yard.
How do you adjust the carburetor on a Homelite chainsaw?
Adjust the Homelite chainsaw carburetor by turning the high- and low-speed screws as needed. Set the high speed screw by adjusting the screw marked “H.” Pull the trigger so that the throttle opens as wide as possible. Turn the screw to the left and note the engine performance.
Where do the fuel lines go on a Homelite chainsaw?
Gas Lines. One gas line extends from the fuel tank to the primer bulb. On Homelite chain saws, this line typically attaches to the longer of the two gas line fittings on the primer bulb.
Which fuel line goes to the primer bulb?
The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb. The return line (blue) comes from the long post on the back of the primer bulb and goes into the bottom of the fuel tank.
What is the fuel mixture for a Homelite chainsaw?
It has a two-stroke engine similar to newer models made by Homelite. The recommended fuel mixture is a 50-to-1 ratio of unleaded gasoline and two-cycle engine oil, and the manufacturer recommends the use of a two-cycle oil that contains fuel stabilizer to keep the mixture fresh if you are not using it immediately.
How do you test a Homelite chainsaw coil?
Pull the start rope on the chainsaw and watch the end of the plug as you do. If you observe a spark jumping between the tips of the spark plug gap, it means the chainsaw coil is good. If there is no spark, it means the chainsaw coil will need to be replaced.
How do I start my Homelite chainsaw?
Pull the choke lever, located underneath the ignition switch, all the way out. Pull the starter cord three times to get the engine revving. Push the choke lever to the “run” position, and squeeze the trigger on the rear handle with your right hand to start the chainsaw.